Emergency Power Off; Electrical Supply - Xerox EC70 User Manual

Safety
WARNING:
strips, or power plugs for more than 90 days. When a permanent outlet receptacle
cannot be installed, use only one factory-assembled extension cord of the appropriate
gauge for each printer or multifunction printer. Always adhere to national and local
building, fire, and electrical codes regarding length of cord, conductor size, grounding,
and protection.
• Do not use a ground adapter plug to connect the printer to an electrical outlet that does not have
a ground connection terminal.
• Verify that the printer is plugged into an outlet that provides the correct voltage and power. If
necessary, review the electrical specification of the printer with an electrician.
• Do not place the printer in an area where people can step on the power cord.
• Do not place objects on the power cord.
• Do not plug or unplug the power cord while the power switch is in the On position.
• If the power cord becomes frayed or worn, replace it.
• To avoid an electrical shock and damage to the cord, grasp the plug when you unplug the power
cord.
The power cord is attached to the printer as a plug-in device on the back of the printer. If it is
necessary to disconnect all electrical power from the printer, disconnect the power cord from the
electrical outlet.
E E m m e e r r g g e e n n c c y y P P o o w w e e r r O O f f f f
If any of the following conditions occur, power off the printer immediately and disconnect the power
cord from the electrical outlet. To correct these problems:
• The equipment emits unusual odors or makes unusual noises.
• The power cable is damaged or frayed.
• A wall panel circuit breaker, fuse, or other safety device has been tripped.
• Liquid is spilled into the printer.
• The printer is exposed to water.
• Any part of the printer is damaged.
Contact an authorized Xerox service representative.
E E l l e e c c t t r r i i c c a a l l S S u u p p p p l l y y
The electrical supply for the device meets the requirements stated on the data plate on the rear of
the device. If you are not sure that your electrical supply meets the requirements, consult your local
electricity provider or a licensed electrician.
WARNING: The device connects to a grounded electrical circuit. The device is supplied with a
grounded electrical plug that fits into a grounded electrical outlet. The power cord plug only
fits into a grounded electrical outlet. The power cord design is a safety feature. If you are
unable to insert the power cord plug into your electrical outlet, consult your local electricity
provider or a licensed electrician. Always connect the device to a properly grounded electrical
outlet.
12 Xerox ® EC70 Color Copier/Printer
User Guide
To avoid risk of fire or electrical shock, do not use extension cords, power