Table of Contents
Advertisement
In order to keep the Speedster® LTD running smoothly
and reduce the risk of damage to the machine and subse-
quent downtime, Mytee recommends following the mainte-
nance schedule below:
Maintenance Item
Clean and inspect tanks.
Clean and inspect hoses.
Check and clean internal filters.
Check power supply cable.
Clean machine with all-purpose
cleaner and cloth.
Check spray nozzles.
Flush solution system with Mytee
System Maintainer.
Inspect vacuum hoses for holes and
loose cuffs.
Inspect spray pattern for clogging.
If clogged, remove spray tips and
soak them in a recommended liquid
neutralizer for up to six hours. To
remove spray tip, twist spray tip
body counter-clockwise.
Lubricate wheels with water
resistant oil.
Inspect machine for water leaks and
loose hardware.
3.1 - Opening the Unit for Maintenance
To open the Speedster® LTD, loosen the rear latches by
turning them one quarter turn counter-clockwise. Flip the
latches down and then lift up on the push handle and the
machine will open up.
♦
3.2 - Filter Maintenance
The Speedster® LTD comes
with a nylon mesh bag filter
that should be placed over
Daily
Weekly
the pump-out filter on the
X
bottom of the recovery
tank. The nylon bag filter,
X
the pump-out filter, and
X
the solution filter inside the
solution tank should be
X
checked and cleaned on a
daily basis.
X
X
3.3 - Ball Float Maintenance
The ball floats in the recovery tank prevent recovered
X
dirty water from rising too high and damaging the vacuum
motors. Clean the mesh screen on the floats regularly.
X
3.4 - System Maintainer
Weekly flushing of the solution system with Mytee®
System Maintainer helps keep lines clean and prevents
X
chemical build-up, improving pump life, performance
and pressure.
How to use System Maintainer:
X
1. Mix 1-quart 3601 System Maintainer with 1-quart of
warm water.
X
2. After thoroughly mixing, pour this solution into the
solution tank.
3. Turn the pump on FIRST, and run solution through your
cleaning tool. NOTE: The jet should be removed from
the cleaning tool in order to prevent clogging due to
loosening of deposits in line.
4. Next, turn on the heater (if equipped). If the heater is
turned on first, it will result in a vapor lock, which will
affect the machine's operation.
5. Next, with both the pump and heater on, begin running
the solution through the machine. This allows the
solution to break down any build up in the lines.
6. After running all of the solution through the machine,
fill the tank with clean, warm water. Run the water
through the machine to clear the solution completely
out of the tank & lines.
13
3 - Machine Maintenance
♦
♦
♦
Advertisement
Table of Contents
