Machine Maintenance; Filter Maintenance; System Maintainer - Mytee Lite 8070 User Manual

3 - Machine Maintenance

In order to keep the Mytee Lite™ running smoothly and
reduce the risk of damage to the machine and subsequent
downtime, Mytee recommends following the maintenance
schedule below:
Maintenance Item
Clean and inspect tanks.
Clean and inspect hoses.
Check and clean internal filters.
Check power supply cable.
Clean machine with all-purpose
cleaner and cloth.
Check spray nozzles.
Flush solution system with Mytee

System Maintainer.

Inspect vacuum hoses for holes and
loose cuffs.
Inspect spray pattern for clogging.
If clogged, remove spray tips and
soak them in a recommended liquid
neutralizer for up to six hours. To re-
move spray tip, twist spray tip body
counter-clockwise.
Lubricate wheels with water resis-
tant oil.
Inspect machine for water leaks and
loose hardware.

3.1 - Filter Maintenance

The Mytee Lite™ has a small filter on the top of the vac-
uum stack in the recovery tank. This filter should be
checked and cleaned after each use.
3.2 - System Maintainer
Regular flushing of the solution system with Mytee Sys-
tem Maintainer keeps your extractor running efficiently by
removing hard water scaling that builds up in the system.
How to use System Maintainer:
1. Thoroughly mix System Maintainer with warm water at a
1:1 ratio in a separate container. Pour into your Extractor's
solution tank.
2. Connect a cleaning tool (upholstery tool, wand, etc.) and
remove the jet(s) in order to prevent clogging from dis-
lodged mineral build-up.
3. Turn on the Extractor's pump and run the System Main-
tainer solution through the system and into a bucket or
receptacle until you have a solid stream.
4. Let sit for about 5 minutes while the System Maintainer
solution does its job inside your Extractor.
Daily Weekly
X
5. Finish running the rest of the solution through the sys-
X
tem.
X
6. Run clean water through the system to flush out any
X
remaining System Maintainer.
X
X
X
X
X
X
X
♦
12
♦
Do not tamper with the set screw on the
pump pressure switch. This can damage the
pressure switch.