Table of Contents
Advertisement
NOTES
1)
1.
The bandwidth of LTE-TDD B41 for SC66-CE* and SC66-J* is 120MHz (2535MHz~2655MHz), and
the corresponding channel ranges from 40040 to 41240.
2)
2.
The bandwidth of LTE-TDD B41 for SC66-A and SC66-E is 200MHz (2496MHZ~2690MHz), and
the corresponding channel ranges from 39650 to 41589.
3.
"*" means under development.
6.1.1. Main and Rx-diversity Antenna Interfaces Reference Design
A reference circuit design for main and Rx-diversity antenna interfaces is shown below. A π-type
matching circuit for each antenna should be reserved for better RF performance, and the π-type matching
components (R1/C1/C2, R2/C3/C4) should be placed as close to the antennas as possible. The
capacitors are not mounted by default and resistors are 0Ω.
ANT_MAIN
ANT_DRX
Module
Figure 36: Reference Circuit Design for Main and Rx-diversity Antenna Interfaces
6.1.2. Reference Design of RF Layout
For user's PCB, the characteristic impedance of all RF traces should be controlled to 50Ω. The
impedance of the RF traces is usually determined by the trace width (W), the materials' dielectric constant,
height from the reference ground to the signal layer (H), and the clearance between RF traces and
grounds (S). Microstrip or coplanar waveguide is typically used in RF layout to control characteristic
SC66_Hardware_Design
Smart LTE Module Series
SC66 Hardware Design
Main
antenna
R1
0R
C2
C1
NM
NM
Diversity
antenna
R2
0R
C4
C3
NM
NM
99 / 139
Advertisement
Table of Contents
