Table 32: Control Byte C0, All Versions, Except 750-637/000-004 - WAGO 750-637 Series Manual

40 Process Image

Table 32: Control Byte C0, All Versions, Except 750-637/000-004

Bit 7
0
EN_LATC
EN_LAT_EXT
CNT_SET
RESET
UNDERFLOW
RESET
OVERFLOW
SetLoad Ext
OpMode
0
Manual
Version 1.6.1
Control Byte C0
Bit 6 Bit 5
OpMode SetLoad RESET
Ext OVER-
FLOW
The initial point of the encoder is enabled
On a positive edge at input C, the counter value is
Capture Mode:
transferred to the Latch register.
On a positive edge at input C, the counter value is
Preload Mode: transferred to the Latch register.
The set value is loaded to the counter.
Confirmation is canceled on a negative edge at EN_LATC. EL_LATC is
dominant over EN_LAT_EXT.
The external Latch input is enabled
On a positive edge at the LATCH input, the counter
Capture Mode:
value is transferred to the Latch register.
On a positive edge at the LATCH input, the counter
Preload Mode: value is transferred to the Latch register.
The set value is loaded to the counter.
Confirmation is canceled on a negative edge at EN_LAT_EXT.
On a positive edge, the counter is initialized to the set value
The UNDERFLOW status bit (S0.3) is reset on a positive edge.
The OVERFLOW status bit (S0.4) is reset on a positive edge.
On a positive edge, the set value to which the counter is to be set
for an external event is transferred to the process data.
OpMode
0: Capture Mode: The counter is latched by a trigger signal
Preload Mode: The counter is latched by a trigger signal.
1:
The set value is then loaded to the counter.
Reserved
Public
750-637 Incremental Encoder Interfaces
Bit 4 Bit 3 Bit 2
RESET CNT_SET
UNDER-
FLOW
WAGO I/O System 750
Bit 1 Bit 0
EN_LAT_ EN_LATC
EXT