IDEC KW2D Series User Manual page 91

2 Hold up the RFID tag to be registered.
Name1 of the successfully registered tag is "ADD TAGXXX" (XXX: Registration position 001 to 500 in the tag list),
Authority (1 to 255) is the authority written in the holding register 0008 in the registration procedure 1, and the
check box of Protect is cleared.
2
Repeat step as many times as the number of RFID tags to be registered. Next, proceed to step
Registering
The LEDs (green) are ON and the LEDs
(white) flash rapidly.
LED (white)
LED (green)
LED (white)
Buzzer
One short beep The LEDs (green) are ON.
Four short beeps The LEDs (red) are ON.
3
Write the tag information to be registered to the holding registers 0009 to 0032 and 10xxh (xx: Authority to set) to
the holding register 0008.
3
Repeat step for the required number of tag information according to the number of RFID tags to be registered. To
execute the same command continuously, after the value of the input relay 0019 changes to 1, write 00xxh (xx:
Authority) to the holding register 0008 to initialize the command, and then write the next command.
Registering
LED (white)
LED (green)
LED (white)
Buzzer
The LEDs (green) are ON and the LEDs (white) flash
One short beep
rapidly. (100 ms interval)
Registration successful
The LEDs (green) are ON.
LED (green)
Registration failure
LED (green)
The LEDs (red) are ON.
LED
Update completed
LED (green)
LED
KW2D Series Smart RFID Reader User's Manual
2 KW2D Series Smart RFID Reader Functions
One short beep
LED （緑）
LED (red)
Four short beeps
LED (red)
Status
Successful registration
Registration failure
LED (white)
LED (green)
LED (white)
Status
Update command (write 10xxh to holding
register 0008) is accepted.
4
.
5
One short beep
LED (green)
5-23