IDEC KW2D Series User Manual page 81

Input relay (0001 to 0064)
●
Address
Description
No.
0001 *1
Verification result
0002 *1
Host communication
0003
status
0004 Project status
0005 Tag list status
0006, 0007 Reserved
0008 Operation mode
0009 Authority D1
*1
Authority D2
0010 *1
Authority D3
0011 *1
0012 *1 Authority D4
Authority D5
0013 *1
Authority D6
0014 *1
Authority D7
0015 *1
0016 Authority D8
*1
KW2D special tag
0017 *1
detection
0018 Reserved
Command execution
0019
*1
status
Command execution
0020
error
0021
Editing status of tag
information
0022
0023 to
Reserved
0064
*1 After reading the RFID tag, the tag information is retained for up to three seconds. After that, it is set to the initial value.
Explanation
When the tag list is registered to the KW2D Smart RFID Reader
and the UID verification result is a match, the value is 1.
When the tag list is registered to the KW2D Smart RFID Reader
and the UID verification result is mismatch, the value is 1.
Indicates the communication status of the Host communication.
0: Communicating, 1: Not communicating
Indicates whether the KW2D Series Smart RFID Reader has a
project.
0: Has a project, 1: No project
Indicates whether or not the tag list is registered in the KW2D
Smart RFID Reader.
0: Registered, 1: No registration
You can check the operation mode of the KW2D Smart RFID
Reader.
0: Running, 1: Stopped
Indicates the authority information of the detected RFID tag.
1 to 255: Authority
However, the content varies based on whether or not the tag list is
registered.
With tag list registration: The UID is verified against the tag list. If
OK, the authority registered in the tag
list is read. For a KW2D
special tag, if authority 1 to 254 is
specified in the tag list, the authority
registered in the tag list is read. If
255 is specified in the tag list, the
authority added to the tag is read.
No tag list registration: For a KW2D special tag, the authority
held in the tag is read. For other tags, 0
is read.
0: KW2D special tag not detected, 1: KW2D Series
special tag detected
0: Waiting for command, 1: Executing command (holds for up to
two seconds then returns to 0. When the value of the holding
register 0008 is set to 0, this value is also set to 0.)
0: Normal, 1: Execution error (holds for up to two seconds then
returns to 0. When the value of the holding register 0008 is set to
0, this value is also set to 0.)
The value is 1 during registration.
The value is 1 during deletion.
KW2D Series Smart RFID Reader User's Manual
2 KW2D Series Smart RFID Reader Functions
-
-
-
Initial
R/W
Value
R 0
R 0
R 0
R 0
R 0
- -
R 0
R 0
5
R 0
R 0
R 0
R 0
R 0
R 0
R 0
R 0
- -
R 0
R 0
R 0
R 0
- -
5-13