Change Fuel Bed Support (If Necessary); Install Liner Panels - Valor LEGEND G3 739JN Installation & Owner's Manual

Change Fuel Bed Support (if necessary)

The appliance is supplied with the log support already
installed. If installing the Log Set 739LSK, ignore this
section and go to the next to continue the installation.
If installing the Rock Set 739RSK you need to remove
the log support and install the rock support.
1. Remove the rear log support from the fi rebox and
keep the screws (4 screws).

Install Liner Panels

The following guidelines apply for all liners except
the 739RGL Refl ective Glass Liners which require
some preparation prior to installation—see instructions
packed with liners.
1. Inside the fi rebox, on the top of each side, release
the screw of the side brick anchors (one per side)
just enough to allow them to rotate.
2. Place the rear panel against the back of the fi rebox,
on the ledge at bottom.
Installation
2. Install the rock support supplied with the ceramic
rocks set re-using the screws from 1. (4 screws).
3. Rotate the anchor up and out of the way and slide
the left hand side panel against the fi rebox side.
The panel should be parallel to the edge of the
burner plate. Rotate the anchor back down to hold
the panel.
Rotate anchor up and
insert panel
QUALIFIED
INSTALLER
Side panels
should be
parallel to
edge of
burner plate
Edge of
burner plate
Position of panel in
relation to burner plate
27