Synchronize Remote Control; Check Operation; Adjust Aeration (If Necessary) - Valor H4 Series Installation & Owner's Manual

Direct vent natural/propane gas
Table of Contents

Advertisement

Synchronize Remote Control

The receiver and the handset of the remote control sys-
tem must be initially synchronized before fi rst use.
1. Insert one 9 V
alkaline
2. Locate the Reset button on the top side of the re-
ceiver.
3. With a narrow object, press and hold the receiver's
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
4. Within the subsequent 20 seconds, press the (small
fl ame button (
) on the remote handset until you
hear two short beeps confi rming the synchroniza-
tion is set.
This is a one time setting only and is not required when
changing the batteries in the remote battery holder.
The remote control system is now ready to use.

Check Operation

Turn the fi replace fl ame up and down using the
remote control to confi rm that the full range of inputs
is achieved—see the remote control operation
instructions starting on page 8.

Adjust Aeration (if necessary)

Light the fi re and allow the unit to warm up for 10–15
minutes to evaluate the fl ame picture. Burners are
equipped with an adjustable shutter to control primary
aeration. See the fi gures below. The shutter is
factory-set to an aeration gap which will give optimum
performance for the vast majority of installations.
Air Shutter
Air Shutter
Slider & Cover
(natural gas)
Installation
battery in the handset.
Natural gas
Close
Open
Close
Open
In some installations, depending of the fuel bed used,
the altitude and other considerations, the fl ame picture
may be improved by adjusting the aeration. The need
for adjustment should be determined only by operating
the appliance with the fuel bed and window installed
and evaluating the fl ame picture after a 15-minute
warm-up.
Increasing aeration will cause the fl ames to appear
more transparent and blue showing more ceramic
eff ects glow.
Decreasing aeration will cause the fl ames to appear
more yellow or orange showing less ceramic eff ects glow.
Too little aeration may result in black carbon
forming and dropping into the fi rebox.
Flashback shield
(propane only)
Air Shutter Slider
(propane gas)
QUALIFIED
INSTALLER
Propane gas
Close
Open
45

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

650jn650jp

Table of Contents