Connecting Gun - Kemppi Flexlite GX Series Operating Manual

3.3 Connecting gun

Hand-tighten the gun connectors. Loose connectors may overheat, create contact disturbances, mechanical damage
and water or gas leakage.
For connecting the gun (and applicable extension parts), refer also to your welding equipment's instructions.
If not already preinstalled, the wire liner must be installed before connecting the gun. Refer to "Installing and repla-
cing wire liner" on the next page for instructions.
1. Connect the gun to your welding equipment. Secure the connector in place by turning the collar clockwise.
2. Water-cooled models only: Connect the coolant inlet and outlet hoses to your welding equipment. Note that
the connectors are color-coded.
Make sure to connect the coolant hoses to the correct hose connectors. If the connections cross, the welding gun may
overheat.
© Kemppi
12/49
Flexlite GX
Operating manual - EN
1921390 / 2002