Kemppi Flexlite GC Operating Manual page 10

4. Feed the new wire liner into the cable hose until it stops at the gun neck end.
Ensure that the contact tip adapter and contact tip are in place at this stage. Otherwise, depending on the welding
gun model, the wire liner will go through without stopping. (With GC 323G only contact tip adapter is required at this
stage.)
To ensure that the wire liner is in the correct position, temporarily remove the welding gun contact tip. For more
information on the contact tip, refer to "About equipment" on page 4 and "Assembling gun" on page 7.
Steel spiral: Cutting wire liner and installing sleeve assembly
1. Cut off the fixed sleeve nut at the end of the wire liner.
© Kemppi
10
Flexlite GC
Operating manual - EN
1921860 / 2109