Table of Contents
Advertisement
Don't leave any rough edges that could potentially damage the filler wire.
6.
Insert first the retainer cone and then the sleeve and end cap on the wire liner. Tighten the sleeve and end cap
in place.
DL Chili: Cutting wire liner and installing sleeve assembly
1.
Insert the sleeve nut (delivered with the wire liner) with the retainer cone on the wire liner and tighten it in
place.
2.
Cut the wire liner flush with the sleeve nut end.
Cut the excess of the Chili liner with a carpet knife.
© Kemppi
12
Flexlite GC
Operating manual - EN
1921860 / 2109
Advertisement
Table of Contents
