Setting Zebra Pattern - JVC GY-HM890U Instructions Manual

Memo :
The built-in time code generator will continue
0
operation even when the master device is
disconnected after synchronization.
User's bit will become data in the master device.
0
While the [TC] terminal is connected, the time
0
code may be out of synchronization when the
[A/V Set] B [Video Set] B [HDMI/SDI Out]
setting of the Master device and Slave device is
being changed.
(A P125 [ HDMI/SDI Out ] )

Setting Zebra Pattern

When the luminance level range for displaying
zebra patterns is specified, diagonal lines (zebra
pattern) are displayed at areas with the specified
luminance levels during shooting.
.
1 Set the zebra display pattern.
Select the display pattern in [LCD/VF] B
[Shooting Assist] B [Zebra].
(A P121 [ Zebra ] )
Zebra 1 Display
Example
.
Zebra 2 Display
Example
Synchronizing the Time Code with an External Time Code Generator
2 Specify the brightness (luminance) level
range for displaying zebra pattern.
Set the maximum brightness limit in [LCD/VF] B
[Shooting Assist] B [Zebra] B [Top 1]/[Top 2],
and the minimum brightness limit in [Bottom 1]/
[Bottom 2].
Item Settings
Top 1 Maximum
brightness limit for
displaying Zebra 1
Bottom 1 Minimum
brightness limit for
displaying Zebra 1
Top 2 Maximum
brightness limit for
displaying Zebra 2
Bottom 2 Minimum
brightness limit for
displaying Zebra 2
Memo :
When [Zebra] is set to "1Pattern", "Top 2" and
0
"Bottom 2" cannot be selected.
If the area specified by two zebra patterns
0
overlaps, the zebra patterns will also appear
overlapped, forming a grid-like display.
.
3 Display the zebra pattern.
Press the [7/H/ZEBRA] button to display the
zebra pattern in the specified range.
.
Memo :
"Zebra" is assigned to the [7/H/ZEBRA] buttons
0
in the factory default.
"Zebra" can also be assigned to other user
0
buttons.
(A P42 [Assignment of Functions to User
Buttons] )
Options
5% - 100%, Over
(in 5 % increments)
0% - 100% (in 5 %
increments)
5% - 100%, Over
(in 5 % increments)
0% - 100% (in 5 %
increments)
79