Table of Contents
Advertisement
Camera Function Menu
Menu screen for specifying operation settings
during shooting.
This item can only be selected in the Camera
mode.
Bars
For setting whether to output color bars.
[Setting Values: On, ROff]
Memo :
The audio test signals (1 kHz) can be output
0
simultaneously with the color bar output.
(A P129 [ Test Tone ] )
This feature will be set to "Off" automatically if
0
you switch the camera recorder from the
Camera mode to other modes or set the
[POWER ON/OFF] switch to "OFF".
OIS F
For setting whether to enable image stabilizer.
When "On" is selected, set the Level.
[Setting Values: On, ROff]
* When the supplied lens is not attached, "---" is
displayed and selection cannot be made.
9 Level
For setting the level of the image stabilizer.
[Setting Values: High, RNormal]
Memo :
When "High" is selected, correcting severe
0
camera shake may cause the area surrounding
the image to darken.
Flicker Correction
For setting whether to adjust image flicker that
occurs under a fluorescent light.
[Setting Values: On, ROff]
Memo :
In any of the following cases, "Off" is displayed
0
and selection cannot be made.
During slow shutter
0
When [Rec Mode] is set to "Variable Frame"
0
When the number of frames of [WFrame & Bit
0
Rate]/[YFrame & Bit Rate] is "24p"
Camera Function Menu
108
Flash Band Correction
For reducing the condition of the flash band
phenomenon, which creates an unnatural image
with a part of it brightly lit, such as by the camera
flash of another still camera.
[Setting Values: On, ROff]
Caution :
Flash band correction function is not available in
0
any of the following cases.
When [Rec Mode] is set to "Variable Frame"
0
When the frame rate of [WFrame & Bit Rate]/
0
[YFrame & Bit Rate] is "24p"
When the shutter speed is set to a value other
0
than OFF
(A P60 [Manual Shutter Mode (Manual
Shutter Switching)] )
When [Network] is set to "On(SDI Off)" or
0
"On(HDMI Off)"
[Flash Band Correction] operates when the
0
luminance of the screen varies widely, with or
without flash light. However, depending on the
shooting condition, the flash band correction
may not be fully effective even if there are flash
lights.
The following symptoms may occur under flash
0
light, but these are not malfunctions due to flash
band correction.
Moving object appears to be stationary
0
momentarily.
A horizontal line appears on the image.
0
The [Flash Band Correction] feature will be set
0
to "Off" automatically if you switch the camera
recorder from the Camera mode to other modes
or set the [POWER ON/OFF] switch to "OFF".
Shutter
For specifying shutter-related settings.
Use this item to set to "Step" (fixed value) or
"Variable" when operating with the cross-shaped
button (JK) on the right side.
EEI:
0
Select this to perform automatic control of the
shutter.
Variable:
0
Sets to variable scan. Use this setting such as
when shooting a PC monitor.
Step:
0
Sets to step shutter, which switches the shutter
speed by a fixed value.
[Setting Values: EEI, Variable, RStep]
Advertisement
Table of Contents
