Ford 1996 Windstar Manual page 212

Using the "SCAN" function
Pressing the "SCAN/TUNE" button once enters the scan
mode (display will indicate "SCN"). Pushing the right ( a )
side of the "SEEK" button will begin the scan mode up the
frequency band, stopping on each listenable station for
approximately a five-second sampling. Pushing the left ( b )
side of the "SEEK" button will begin the scan mode down
the frequency band, again stopping on each listenable station
for approximately a five-second sampling.
To stop the scan mode on the presently sampled station
press the "SCAN/TUNE" button again.
Setting the station MEMORY PRESET buttons
Your radio is equipped with 5 station memory buttons.
These buttons can be used to select up to 5 preset AM
stations and 10 preset FM stations (5 in FM1 and 5 in FM2).
Follow the easy steps below to set these buttons to the desired
frequencies:
Select a band, then select a frequency.
1.
Press one of the memory buttons and hold the button until
2.
the sound returns. That station is now held in memory on
that button.
Follow the two steps above for each station memory preset
3.
button you want to set.
210