Ford 1996 Windstar Manual page 201

With Auto Memory Store, you can continually set strong
stations into your memory buttons without losing your
existing memory presets, which is especially handy while
traveling. Your radio will automatically set your memory
buttons to the strong local stations so you don't have to
continually manually tune to existing stations.
Activate Auto Memory Store by pushing the "AUTO
PRESET" button once. Your radio will set the first five
strong stations of the band you are in (AM, FM1 or FM2)
into the memory buttons. The display will show "AUTO",
then run through the frequencies, stopping momentarily on
the stations being set into the memory buttons. The radio is
now in the "AUTO" mode and this display will show
"AUTO" each time a preset is activated.
NOTE: If there are fewer than five strong stations in the
frequency band, the remaining unfilled buttons will
store the last strong station detected on the band.
After all stations have been filled, the radio will begin
playing the station stored on memory button 1.
To deactivate the Auto Memory Store mode and return to
the manually-set memory button stations (or those stations
set using Auto Memory Load), simply push the "AUTO
PRESET" button. Display will show "AUTO" then "OFF".
The next time Auto Memory Store is activated on that band,
the radio will store the next set of five strong stations.
Using the "AUDIO" button to adjust the tone balance
and speaker output
Increasing or decreasing bass response
Push the "AUDIO" button repeatedly until the display reads
"BASS." Push the "+" side of the "VOL" button to increase
bass (more "lows"), and push the "-" side to decrease bass
(less "lows").
Electronic Sound Systems
199