Available Sizes & Power Sources - PICOTE Smart Cutter DN100 Operating & Safety Manual

AVAILABLE SIZES & POWER SOURCES
TM
The Smart Cutter is a fine tuning tool. It can be used to fine tune remaining edges af-
ter a connection has been reinstated using the Twister tools. The Smart Cutter
be used to remove any remaining lining or inconsistencies, after the collapsed lining has
been removed using a Smart Crusher, Sweeper or Grinding Chains. The side grinding
panels adapt to the pipe size when the tool rotates.
Selecting the correct Smart Cutter for the job
Choose your Smart Cutter according to the size of the original host pipe.
TM
SMART CUTTER
TM
Smart Cutter DN100 / 4"
TM
Smart Cutter DN150 / 6"
TM
Smart Cutter DN200-DN300 /
8"-12"
CHOOSING YOUR POWER SOURCE
The Smart Cutter for the 18mm/¾" diameter shaft has been designed for and can ONLY
be operated with the Picote Maxi Miller Power+ machine.
The machine should only be connected only to a 380-480 Volt (3-phase) power supp-
ly. The power source has to be grounded (earthed).
Shaft size BEND 90°
mm/inches
18 / ¾"
18 / ¾"
18 / ¾"
TM
can also
BEND 45°
YES YES
YES YES
YES YES
6