PICOTE Smart Cutter DN100 Operating & Safety Manual page 14

Using the Smart Cutter
After Use
WARNING: Turn the power off and isolate the supply before you remove the tool from the
pipe. There is a risk of serious injury or death!
out from the pipe.
Check out the condition of the tooling and shaft. Replace any worn-out parts. If the shaft looks
damaged, remove decrepit part with an angle grinder and shorten outer casing accordingly.
RECOMMENDATIONS
Do not turn power on when the Smart Cutter
ing needs to be installed completely inside the pipe before you turn the power
on.
To begin select rotational speed between 650—800 rpm. After you have grinded
sharp edges the rotational speed can be increased to 1100—1300 rpm.
Where ever possible use water as the cooling medium.
Always take a break every 30 mins to prevent the outer casing from melting. Reg-
ularly inspect the condition of the outer casing.
To improve the efficiency and cut down work time you regularly need to change
the side grinding panels.
TM
Please read safety information on
page 3 before assembly and use.
The tool can be very hot. Carefully take the tool
TM
is outside of the drain! The tool-
14