PICOTE DN100 Operating & Safety Manual
Original & mini cannon
Hide thumbs
Also See for DN100:
- Operating & safety manual (25 pages) ,
- Operating & safety manual (19 pages)
Advertisement
Quick Links
Operating & Safety Manual
Original & Mini Cannon
These instructions are for your personal safety. Always ensure that you
have read and understood these instructions before using any Original
and Mini Cannon tools.
We now have resellers in the U.S., Europe & Australasia.
Locate your reseller at picotesolutions.com
I
N
S
T
R
U
C
T
I
O
N
S
Advertisement
Related Manuals for PICOTE DN100
Summary of Contents for PICOTE DN100
- Page 1 Operating & Safety Manual Original & Mini Cannon These instructions are for your personal safety. Always ensure that you have read and understood these instructions before using any Original and Mini Cannon tools. We now have resellers in the U.S., Europe & Australasia. Locate your reseller at picotesolutions.com...
-
Page 2: Table Of Contents
TABLE OF CONTENTS TOPIC PAGE/S SAFETY INFORMATION & SYMBOLS AVAILABLE SIZES & POWER SOURCES ASSEMBLY & USE PRACTICAL TIPS & SAFETY ADVICE MAINTENANCE & SPARE PARTS WARRANTY POLICY & PROCEDURE To watch practical demonstration videos, or to download an electronic copy of these In- structions, please visit www.picotesolutions.com. -
Page 3: Safety Information & Symbols
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE SAFETY INFORMATION This section contains important safety information. Failure to comply could result in serious injury or death. Safety Symbols Safety symbols are used throughout this manual to draw attention to potential hazards. Danger risk of serious injury or death by electrocution, follow instructions Danger risk of serious injury or death by electrocution, follow instructions Danger risk of serious injury, follow instructions... -
Page 4: Available Sizes & Power Sources
-Place (CIPP) linings and repairs for the inside of buildings. Available for the rehabilitation of pipe sizes up to DN100 (4”). Its transparent appearance and the ability to deploy a CCTV camera, inside the lining, during installation enables the engineers to successful install linings in difficult situations. -
Page 5: Assembly & Use
ORIGINAL & MINI CANNON RANGE First, make sure you have all the required parts. Please read safety information on page 3 before assembly and use. ORIGINAL CANNON MINI CANNON 2360000001 Original Cannon 2360000003 Mini Cannon... - Page 6 User Instructions — CCTV Camera Remove the washers, felt plug and the cap from the Air Inlet Cap (Rear Cap) and insert the camera inside the cannon. Push the camera cable in the centre of the felt plug.
- Page 7 User Instructions—Choosing Inversion Head Step 1. Choose inversion head according to liner. Combine with Quick Lock Cap.
- Page 8 User Instructions — Changing the inversion head. Step 2. Open the Camlock and insert the inversion head. Step 3. Close the Camlock handles.
- Page 9 User Instructions — Using Curing Caps. Use Cannon Fast Caps with Camlock system to enable fast installation of multiple linings.
-
Page 10: Practical Tips & Safety Advice
Quick Lock Cap to ensure the lining stays pressurized until it is fully cured. PLEASE NOTE: The Picote Sentinel System can be used to monitor the pressure of the compressor and electricity network. It alerts if either one is lost, warning the engineers and allowing them to react accordingly. -
Page 11: Maintenance & Spare Parts
Inversion Head DN50-DN60 (2”) 900000505 Inversion Head DN70 (3”) 900000506 Inversion Head DN100 (4”) 2360000004 Cannon Fast Cap Please contact your reseller for more information. TRAINING For information about product training and support contact Picote Solutions or your authorized Picote reseller. -
Page 12: Warranty Policy & Procedure
WARRANTY POLICY AND PROCEDURE Limited Warranty: Picote warrants to the original End User that the Product purchased by such End User will operate in accordance with and substantially conform to their published specifications when shipped or otherwise delivered to the End User and for a period of one (1) year, except electric motors for which the warranty... - Page 13 Revision number: Rev. 1 Author: Mikko Långvik Accepted: For support support@picotesolutions.com For accessories Your reseller or Manufacturer sales@picotesolutions.com Picote Solutions Oy Ltd +44 (0)7585 116508 Raudoittajantie 4 +1 219 440 1404 06450 Porvoo Finland Technical Support: +1 706 436-1892 www.picotesolutions.com...
Need help?
Do you have a question about the DN100 and is the answer not in the manual?
Questions and answers