PICOTE Smart Cutter DN100 Operating & Safety Manual page 4

SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
Safety Symbols cont.
Safety symbols are used throughout this manual to draw attention to potential hazards.
Always remember
Dust produced can be dangerous to your health, inflammable or explosive.
Make sure the drain pipe has been opened and ventilated to stop any gases
forming in the lateral drain where the work takes place.
Before assembly, use, replacement of parts or maintenance, unplug the Picote
milling machine or your hand drill from its power socket.
ELECTRICAL SET UP REQUIREMENTS FOR MAXI MILLER POWER PLUS
READ THE MAXI MILLER POWER+ MANUAL BEFORE USE
Electrical shock can cause serious or fatal injury. Only qualified personnel
should install, maintain or troubleshoot this equipment.
Picote recommends that a properly trained electrician be available to wire a
power distribution box to whatever power source is available. In the case
where a generator is required, a minimum power requirement of 25,000
KW/KVA 3 Phase 480 volt is necessary.
The Power Plus is a dual voltage 3 phase power configuration. It uses a 10 gauge 4
wire cord.
Be sure the system is properly grounded/earthed before applying power. Do not apply power be-
fore you ensure that grounds are connected. Electrical shock can cause serious or fatal injury.
Follow the National Electrical Code (NEC) and local codes for the safe installation of the equip-
ment.
Do not operate the Power Plus Miller until you are sure that you are completely familiar with the
safe operation of the machine, all accessories and safety equipment. Improper use can lead to
severe injury. The user manual defines proper use of this equipment.
Contact Picote if you do not understand any procedure or operation concerning this
equipment or the user manual.
High voltage. Failure to comply may lead to serious injury in-
cluding electric shock or injury from rotating parts!
4