ITW Dynatec DPC2 Operation And Service Manual page 41

ITW Dynatec c. 1999
DPC-2 CONTROL KIT Manual #50-06
5. Depress the CHANNEL 1 button. The LED above this button will illuminate and the
LED to the left of EVENT will also illuminate. Rotate the VALUE knob until 1 is
displayed. This indicates the programming of EVENT 1 of the selected Program.
6. Depress the CHANNEL 1 button until the LED to the left of DELAY is illuminated.
Select the value 02.50 by depressing the DIGIT button and rotating the VALUE knob.
7. Depress the CHANNEL 1 button until the LED to the left of LINE is illuminated.
Select the value 03.00 by depressing the DIGIT button and rotating the VALUE knob.
The DPC-2 would produce a solid glue line three inches in length if the machine were
to run at this point in the programming.
8. Depress the CHANNEL 1 button until the LED to the left of GAP is illuminated.
Select the value 00.50 by depressing the DIGIT button and rotating the VALUE knob.
The glue LINE length is divided by the GAP to produce the appropriate number of
dots. The dot duration is determined by the value entered into SPIKE TIME and the
response capability of the glue applicator.
9. Depress the CHANNEL 1 button until the LED to the left of STITCH is illuminated.
The value of this parameter should read 00.00 since dots are desired.
10. Depress the CHANNEL 1 button until the LED to the left of SPIKE TIME is
illuminated. Use the DIGIT button and VALUE knob to set the appropriate SPIKE
TIME for the Glue Applicator (approximately 2ms, 002.0). This value can be adjusted
as the glue system is operating until the desired dot size is achieved.
11. Depress the CHANNEL 1 button until the LED to the left of EVENT is once again
illuminated. Rotate the VALUE knob until 2 is displayed. This indicates the
programming of EVENT 2 of the selected Program.
12. Depress the CHANNEL 1 button until the LED to the left of DELAY is illuminated.
Select the value 06.50 by depressing the DIGIT button and rotating the VALUE knob.
There is a total of 6.50 inches from the leading edge of the product to the end of the
DELAY in the second gluing EVENT.
13. Depress the CHANNEL 1 button until the LED to the left of LINE is illuminated.
Select the value 03.00 by depressing the DIGIT button and rotating the VALUE knob.
The DPC-2 would produce a solid glue line three inches in length if the machine were
to run at this point in the programming.
14. Depress the CHANNEL 1 button until the LED to the left of GAP is illuminated.
Select the value 00.50 by depressing the DIGIT button and rotating the VALUE knob.
A series of dots would be put down at this point if no value is entered for STITCH.
15. Depress the CHANNEL 1 button until the LED to the left of STITCH is illuminated.
Select the value 00.50 by depressing the DIGIT button and rotating the VALUE knob.
The glue LINE length is divided using the STITCH and GAP values to produce the
appropriate number of stitched lines within the three-inch pattern.
Page 4 - 5
Revised 7/99