Installation Procedure; Installation Diagram Of Indoor And Outdoor Units; Before Installing The Wireless Remote Controller - Toshiba RAS-B05J2KVG-E Service Manual

10-1. Installation Diagram of Indoor and Outdoor Units

Batteries
3
6
Flat head
wood screw
2
Wireless remote control
RAS-05,07J2AVG-E RAS-16J2AVG-E
RAS-18J2AVG-E
RAS-10,13J2AVG-E
600
C
D 400
E 45
F 100
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (-) positions.

10. INSTALLATION PROCEDURE

Refrigerant piping
must be protected from
physical damage.
Install a plastic cover or
equivalent.
Vinyl tape
Apply after carrying
out a drainage test.
4
Remote control
holder
600
600
100
100

Before installing the wireless remote controller

2 Wireless remote controller
Hook
Installation
1
plate
Shield pipe
Saddle
Extension drain hose
(Not available, provided
by installer)
- 58 -
FILE NO. SVM-19001
For the rear left, bottom left and left piping
Wall
Cut out a piece of SPACER from indoor
unit packaging box, roll it and insert
between the indoor unit and wall to tilt
the indoor unit for better operation.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Bottom Rear
right left
Bottom left
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose sloped
downward.
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
3 Batteries
Left