Installation Procedure - Toshiba RAS-25S4KVDG-ND Service Manual

10-1. Installation Diagram of Indoor and Outdoor Units
Mounting
screw
5 Filter
Flat head
7
wood screw
Remote controller
4
holder
Wireless
2
remote controller
• Loading Batteries
1. Remove the slide cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (-) positions.

10. INSTALLATION PROCEDURE

Hook
6
Hook
Hook
Vinyl tape
Apply after carrying
out a drainage test.
3 Batteries
Before installing the wireless remote controller
2 Wireless remote controller
Installation
1
plate
Shield pipe
Saddle
Extension drain hose
(Not available, provided
by installer)
3 Batteries
- 73 -
For the rear left and bottom left piping
Wall
Cut out a piece of SPACER from indoor
unit packaging box, roll it and insert
between the indoor unit and wall to tilt
the indoor unit for better operation.
The auxiliary piping can be connected
to rear left, rear right, bottom right or
bottom left.
Rear right
Bottom Rear
right left
Bottom left
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose sloped
downward.
Refrigerant piping must be protected
from physical damage.
Install a plastic cover or equivalent.
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam