Self-Cleaning Diagram; Self-Cleaning Function Release - Toshiba RAS-B05J2KVG-E Service Manual

Item
14. Self-Cleaning
function

13-1-1. Self-Cleaning diagram

Operation display
FCU fan
rpm is depend on presetting.
FCU louver
Timer display
depend on presetting of timer function.
Compressor
depend on presetting per room temperature.
CDU fan
depend on presetting per room temperature.
operation more than 10 mins.

14-1-2. Self-Cleaning function release

How to set/cancel Self-Cleaning function
To set/cancel the Self-Cleaning function, proceed as
follows:
· Setting diagnosis code "06" on remote controlle
(See detail of setting diagnosis code in 11-4-1)
· Turn on the power supply to air conditioner, after
that press [RESET] button on air conditioner 1
time to turn on the air conditioner (The LED
display will show in operation LED)
·
Take the remote controller to direction of LED
display on air conditioner, press button "up" (see
detail of setting diagnosis code in 11-4-1) 1 time
to send the code "07"
*(within 3 sec. after press [RESET] button),* then
air conditioner will shutdown automatically. Also,
LED display will show flash follow the able below.
Self-cleaning
Operation LED
function
ON flash 1 Hz
flash 1 Hz
OFF
Note) Table above will show current status of
Self-Cleaning function
Operation flow and applicable data, etc.
ON
ON
OPEN
ON or OFF
ON or OFF
ON or OFF
Cool mode or dry mode
Turn off by remote controller or
timer-off function.
1
Timer LED
not flash
Flash 1 Hz
OFF
ON
(500RPM)
OPEN (12.7º)
ON
OFF
OFF
Self-Cleaning mode
operate 30 mins.
Automatically turn-off.
Set or Cancel Self-Cleaning function by push
•
the RESET button on air conditioner.
When setting is changed, the sound warning will
alarm "Beep". The setting is changed following
below.
ON
Turn on air conditioner again by remote controller
•
to confirm setting.
OPERATION /
RESET Button
- 49 -
FILE NO. SVM-19001
Description
OFF
OFF
CLOSE
ON or OFF
depend on presetting of timer function.
OFF
OFF
Operation time
OFF ON
OFF
1