Kessel Ecolift Instructions For Installation, Operation And Maintenance page 42

Inspection/maintenance Ecolift
Please note the safety instructions
Name of the building
Building
Street
Postcode, city
Contact
System variant
Serial number
Pump type
Inspection: Once a month by the operator:
No. Test
1
Check the display of control unit for possible fault messages
2
Manual function test on the control unit, close flap (using flap test hand symbol). Make sure
of inflow (clear water) ➞ wait to see if the pump starts working
A rising level can be seen on the display. Inlet until switch-on point 1 or switch-on point 2 has been reached, then
pump operation starts.
"On" level: ______________________
"Off" level: ______________________
3
If pump is pumping ➞ stop inflow
4
Open the flap of the control unit again manually
If a fault message appears, proceed according to the control unit instructions.
Maintenance: by a maintenance expert in accordance with the maintenance interval:
No.
Test
8
Steps 1-4 must be carried out as described above.
9
Open the cover and check the cover seal for damage
10
Visual inspection of the upper section
11
Disconnect the system from the mains and secure it against being switched on again
12
Remove dirt and deposits
12.1
Check sealing gaskets and sealing surfaces for perfect condition; if necessary replace the
sealing gaskets
12.2
Check the mechanisms of the moving sealing parts, if necessary re-grease
12.3
Carry out a function test to establish the airtightness of the operating valve (motor)
12.4
Test and clean the electric probe
12.5
Remove the screws, pull the probe out of the cover
12.6
Immerse the probe in water
12.7
The flap must close, the optical and acoustic warning device must respond
12.8
Push the probe with sealing gasket into the cover, screw in place
Maintenance
Mono ❏ Duo ❏
1 ❏ 2 ❏
42 / 144
Done record
yes no
Done record
yes no
04/2017