Arena Controller Tab; L2Tpv3 Settings - Alvarion WBSIac User Manual

Chapter 2 - Management
2.5

Arena Controller Tab

APs running the WBSIac AP firmware can be managed by the Arena Controller.
The Arena Controller sends and receives information from the WBSIac APs using the SNMP protocol.
The settings can be seen by clicking the Arena controller top-level tab.
When using the Arena Controller for the first time, you only need to set the IP address of the Arena
Controller. This has to be done in the AP's configuration web page itself. All other settings should
remain as the default values for now.
Always click Save & Apply. Do not just click Save. This is to apply the settings immediately.
2.5.1

L2TPv3 Settings

The following are the settings for the Layer 2 Tunneling Protocol Version 3 (L2TPv3).

Remote Server: Configures the IP address of the Arena Controller, e.g., 192.168.3.178.

Chap-username: Sets the username for the Challenge-Handshake Authentication Protocol (CHAP).

Chap-secret: Sets the password for the Challenge-Handshake Authentication Protocol (CHAP).
WBSIac Access Point User Ma n ua l
Figure 2-106: Arena Controller
Tab
Figure 2-107: L2TPv3 Settings
Arena Controller
Tab
82