Alvarion WBSIac User Manual page 84

Chapter 2 - Management
The Firewall - Port Forwards page allows you to change advanced properties of the port forwarding
entry. In most cases there is no need to modify the settings.
The following are the Firewall - Port Forwards parameters that can be edited:

Rule is enabled: Enabled by default

Name: The name of the port forwarding entry

Protocol: Select from the following protocols: TCP+UDP, TCP, UDP, ICMP or custom

Source zone: Select the source zone: WAN, LAN or a new zone

Source MAC address: Select a MAC address that only matches incoming traffic from these MACs.

Source IP address: Select an IP address that only matches incoming traffic from the IP or range;
default is "any".

Source Port: Select a source port that only matches incoming traffic originating from the given
source port or port range on the client host; default is "any".

External IP address: Select an external IP address that only matches incoming traffic directed at the
given IP address; default is "any".

External Port: Matches the incoming traffic directed at the given destination port or port range on
the host.

Internal Zone: Select an internal zone, i.e., LAN, WAN or a new zone

Internal IP address: The IP address where to redirect matched incoming traffic to the specified
internal host

Enable NAT loopback: Enabled by default

Extra arguments: Passes additional arguments to iptables.
WBSIac Access Point User Ma n ua l
Network Tab
77