Alvarion WBSIac User Manual page 59

Chapter 2 - Management
2.4.3.1.3 Physical Settings

Enable STP: Enables the Spanning Tree Protocol on this bridge. It is unchecked by default.
2.4.3.2 DHCP Server
This section allows you to configure the device as a DHCP server.
2.4.3.2.1 General Setup

Ignore interface: Disables DHCP for this interface. You should uncheck this to enable DHCP.
NOTE! All the following options in this DHCP Server section depend on DHCP being enabled.

Start: Specifies the lowest leased address as offset from the network address, the default being 100.

Limit: Sets the maximum number of leased addresses, the default being 150.

Leasetime: States the expiry time of leased addresses, the default being 12h.
2.4.3.2.2 Advanced Settings
WBSIac Access Point User Ma n ua l
Figure 2-64: LAN - Physical Settings
Figure 2-65: LAN - DHCP Server - General Setup
Figure 2-66: LAN - DHCP Server - Advanced Settings
Network Tab
52