Alvarion WBSIac User Manual page 17

Chapter 2 - Management

Channel: Shows the channel number and frequency that the AP is using.

Bitrate: This is the maximum bitrate supported by the radio in the current configuration.

BSSID: This is the MAC address of the AP's radio.

Encryption: Displays the wireless encryption used.

ACK Timeout: Shows the maximum acknowledgment time in microseconds.

DFS Status: If DFS is enabled, the AP automatically switches channel if radar is detected on the
current channel.
2.1.1.2 Wireless (for Station Mode)
The following describes the parameters for a device operating in Station mode.
The Wireless section shows a summary of the device operating as an 802.11ac station.

SSID: Displays the name of the wireless network that the station should be associated with.

Mode: This is 'Client' when the device is in Station mode or in Station WDS mode.

Channel: Shows the channel number and frequency that this station is using. Normally, it would
automatically select the same channel as the AP.

Bitrate: This is the maximum bitrate supported by the radio in the current configuration.

MAC-Address: States the MAC address of the device's radio.

BSSID: This is the MAC address of the AP's radio.

Encryption: Displays the wireless encryption used.

ACK Timeout: Shows the maximum acknowledgment time in microseconds.

DFS Status: If DFS is enabled, the AP automatically switches channel when radar is detected on the
current channel.

TX-CCQ: Displays the transmission quality in %. A higher percentage means a better wireless
connection quality.

RX Rate: Shows the receive bit rate of this station.

TX Rate: Shows the transmit bit rate of this station.
WBSIac Access Point User Ma n ua l
Figure 2-4: Wireless Parameters for Station Mode
Status Tab
10