Alvarion WBSIac User Manual page 18

Chapter 2 - Management
2.1.1.3 Associated Stations (for AP Mode)
This section shows the connected devices, if the WBSIac AP is in the AP mode.
If there are no associated stations, the text "No information available" is displayed.
The parameters shown are as follows:

MAC-Address: Displays the MAC address of the station's radio.

Network: States the name of the wireless network.

Device Name: Shows the name of the station.

Last IP: States the most recent IP address of the station as seen by the AP.

Signal: Displays the received signal strength from the station, e.g., -31 dBm.

Signal/Chains: Shows the received signal strengths from the station on each antenna, e.g., -52, -35,
-34 dBm. The value of -95 dBm is taken to mean "no antenna" if the radio has only 2 antennas.

Noise: Displays the received noise power at the AP.

TX Rate: Shows the transmit bit rate from the AP towards this station.

RX Rate: Shows the receive bit rate at the AP from this station.

TX-CCQ: Indicates the wireless connection quality.
2.1.1.4 System
This System section shows the following information:

Router Name: The name of the Access Point

Router Model: The model of the Access Point

Firmware Version: The AP's firmware version

Kernel Version: The version of the kernel

Local Time: Displays the local time
WBSIac Access Point User Ma n ua l
Figure 2-5: List of Associated Stations
Figure 2-6: System Parameters
Status Tab
11