Alvarion WBSIac User Manual page 36

Chapter 2 - Management
2.2.4.1 SNMP Information
The following parameters are displayed in the SNMP Information section:

SNMP Enterprise ID

Contact

Location.
2.2.4.2 SNMP Configuration
2.2.4.2.1 General Settings

Enable SNMP: Enables SNMP.

SNMP V2c Read Password: Sets the community string for read-only access (to the variables on the
SNMP agent) by the network management station (NMS). The NMS is the software which runs on the
SNMP manager, (default: public)

SNMP V2c Write Password: Sets the community string for read-write access by the SNMP manager,
(default: private)
A community string identifies a group of SNMP agents. It is sent in clear text. It should be changed
from the default string public or private. The variables on the SNMP agent can be classified into
read-only or read-write variables.

SNMP V3 Username: Sets the username for authentication (default: admin)

SNMP V3 Auth Algorithm: Shows the authentication algorithm used, e.g., MD5.

SNMP V3 Auth Password: Configures the password for user authentication (default: password)

SNMP V3 Privacy Algorithm: Shows the data encryption algorithm used, e.g., DES.

SNMP V3 Privacy Password: Sets the password for data encryption (default: password)
WBSIac Access Point User Ma n ua l
Figure 2-36: SNMP Information
Figure 2-37: SNMP Configuration - General Settings
System Tab
29