Physical Hardware Button - Alvarion WBSIac User Manual

Chapter 2 - Management
2.2.4.2.2 Trap

Enable SNMP Trap: Allows the SNMP agent to notify the SNMP manager of events.

SNMP Trap IP Address: Sets the IP address of the SNMP manager which receives the trap messages.

SNMP Trap Port: Sets the port number.
2.2.5

Physical Hardware Button

There is a physical button on the Access Point hardware board. Depending on how long the button is
pressed, you can reboot the board or reset it to factory default. First, make sure then power is on. The
following table shows the duration of the button press and the corresponding action.
Duration of button press
0 - 3 seconds
4 - 30 seconds
more than 30 seconds
WBSIac Access Point User Ma n ua l
Figure 2-38: SNMP Configuration - Trap
Action
Reboot
Reset to factory default
Does nothing
System Tab
30