Alvarion WBSIac User Manual page 60

Chapter 2 - Management

Dynamic DHCP: Dynamically allocates DHCP addresses for clients. If disabled, only clients having
static leases are served. Checked by default.

Force: Forces DHCP on this network even if another server is detected, unchecked by default.

IPv4-Netmask: Overrides the netmask sent to clients. Normally it is calculated from the subnet that is
served.

DHCP-Options: Defines additional DHCP options, for example "6,192.168.2.1, 192.168.2.2" which
advertises different DNS servers to clients. Normally, connected devices would take this board's IP
address as the default gateway. To set an alternative default gateway, add the DHCP option
"3,192.168.2.3" for example.
2.4.3.3 Static Leases
In this section, you can specify that a particular DHCP client obtain an IP address that you define. The
MAC address of the client is required.
Click the Add button to add a static DHCP lease, then click Save & Apply to apply the changes.
The static DHCP lease shows up on the Status > Overview page if the client is active.
WBSIac Access Point User Ma n ua l
Figure 2-67: LAN - Static Leases
Figure 2-68: Adding a Static Lease
Figure 2-69: Static DHCP Lease
Network Tab
53