Interfaces - Avlan3316 - Alvarion WBSIac User Manual

Chapter 2 - Management
2.4.1.1.3 Physical Settings

Interface: Chooses which physical interface to use for the WAN zone. This can be the Ethernet
Adapter "eth0" or "eth1" that corresponds to each of the two ports on the device for example. It
could also be set as the Wireless Network. If No Interface is selected, all interfaces would be within
the LAN zone.
For boards with 2 ethernet ports, both ports would be LAN ports in the default configuration. You can
NOTE!
still designate the WAN port in the firmware. For APs with power over Ethernet (PoE), only the port
further away from the DC Jack (right port) would be the PoE input port (ethY). The port nearer to the
DC Jack (left port) would be the PoE output port (ethX).
2.4.2

Interfaces - AVLAN3316

2.4.2.1 Common Configuration
2.4.2.1.1 General Setup
WBSIac Access Point User Ma n ua l
Figure 2-60: WAN Zone - Physical Settings
Figure 2-61: AVLAN3316 Common Configuration
Network Tab
48