Table of Contents
Advertisement
PART 2: BASIC OPERATION
PERFORMING A "HARD RESET" WITH THE
NEWTON+
A Hard Reset reboots your Newton+'s computer.
In the Newton+, you do a "Hard Reset" by doing the following:
Simultaneously press-hold the left, bottom, right, and center buttons. The screen
will go blank. Then, release the button and the Newton+ will restart.
All of your stored information will be retained, with the exception of date and time.
FINE-TUNING NEWTON+ CALIBRATION WITH
ISAAC SOFTWARE
You can fine-tune your Newton+'s calibration even more by entering Basic Information with
Isaac software. It's simple to do, and we strongly recommend you take a few minutes to
do so.
The Isaac software, included with your iBike Newton+, provides an extremely simple way
to enter your basic information. Install the Isaac software on your computer, then connect
your Newton+ to your computer and launch the Isaac software.
"Dial-In Wizard"
The "Dial-In" wizard increases the accuracy of your calibration. Each time Isaac detects
that you've done a Cal Ride that started from a factory-default profile, you'll be prompted
to enter information using the "Dial-In Wizard". Just answer a few questions regarding
your weight, height, ride position, and FTP (if you don't know what FTP is, don't worry—
leave the number at "81", the default value. To learn more about FTP, please refer to pgs
45-47 of these instructions).
"Set-Up Device Wizard"
If you prefer, you can use the "Device/Device Setup..." wizard to enter your basic
information BEFORE you perform the Cal Ride. If you use the Setup Device wizard prior to
the cal ride, then your Newton+ will be fully dialed-in immediately after the cal ride is
completed.
TIP: If you use the Setup Device wizard prior to a Cal Ride, the Dial-In wizard won't
appear after your Cal Ride is completed.
7
Copyright Velocomp LLP 2005-2013
Advertisement
Table of Contents
