iBike Newton+ Operating Instructions Manual page 52

Power meter

Table of Contents

I PURCHASED A FIRMWARE KEY FOR MY NEWTON+. WHAT HAPPENS NEXT?

You will receive an email asking you to send us the serial number of your Newton+. After

we receive your serial number we will email your firmware key to load into your Newton+

with Isaac software.

WHAT IS "TOTAL VERTICAL CLIMBED"?

Any time you climb, the Newton+ will accumulate the amount of elevation gain.

Example: You climb a 100 foot hill, then descend 50 feet downhill, then slowly climb

another 25 feet, and then ride back to your starting spot, descending 75 feet along

the way. The Newton+ will show your Total Vertical as 100 + 25 = 125 feet.

DOES "TRIP RESET" ZERO-OUT SETUP, CALIBRATION, AND PREVIOUS RIDE

DATA?

No! Your total odometer, tilt and coast down calibrations, wireless IDs, and other profile

information are unaffected by trip reset. Also, any ride files recorded from prior rides is

unaffected.

IS THE NEWTON+ SUITABLE FOR RAINY RIDES?

Yes! Your Newton+ was designed to be water resistant so don't worry if you get it wet. If

the front port becomes filled with water your power readings may be wrong. To correct

this problem, remove your Newton+, blow the water out of the front port, and dry your

mount and underside of the Newton+ with a dry cloth. Replace and continue on your ride.

TIP: IF YOU RIDE OFTEN IN RAINY CONDITIONS, CONSIDER PURCHASING THE OPTIONAL

REMOTE WIND SENSOR (RWS). THE RWS WILL KEEP RAIN FROM FILLING THE

NEWTON+'S WIND PORT AND WILL IMPROVE WATTS ACCURACY DURING RAINY RIDES.

HOW DO I HARD RESET THE NEWTON+?

Your Newton+ contains a microprocessor. It is possible, though extremely unlikely, that

your Newton+ might "freeze". Symptoms of a freeze include: the buttons do not function

properly, the screens are frozen, or you can't download rides. A Hard Reset will fix this

problem. To do a "hard reset" press-hold the left, bottom, right, and center buttons

simultaneously. The screen will go blank. Release the buttons to restart.

NOTICE:

AFTER YOU DO A HARD RESET YOU WILL NEED TO RESET THE DATE AND

TIME IN YOUR NEWTON+. HOWEVER, YOU WILL NOT NEED TO RE-ENTER

WEIGHT, TIRE CIRCUMFERENCE, AND CALIBRATION DATA. THAT DATA IS

STORED PERMANENTLY IN THE NEWTON+'S NON-VOLATILE MEMORY. ALSO, ALL

OF YOUR STORED RIDE FILES WILL REMAIN IN YOUR NEWTON+ AFTER A HARD

RESET.