iBike Newton+ Operating Instructions Manual page 7

NOTICE: ONCE BEGINNING YOUR CAL RIDE, IF YOU WISH TO TERMINATE IT, PRESS-
HOLD THE CENTER BUTTON FOR TWO SECONDS. THIS ABORTS THE CAL RIDE AND
LEAVES ANY PRIOR RESULTS UNCHANGED.
IMPORTANT: UNTIL YOU COMPLETE THE CAL RIDE, YOU WILL SEE "---W" IN THE MAIN
SCREENS, INDICATING THAT YOUR CAL RIDE HAS NOT BEEN COMPLETED AND THAT
YOUR NEWTON+ IS NOT SET UP PROPERLY. YOU MUST COMPLETE THE CAL RIDE BEFORE
USING YOUR NEWTON+ FOR ANY BIKE RIDE MEASUREMENTS.
BASIC SETUP OF YOUR NEWTON+ IS NOW COMPLETE AND YOU'LL GET
CONSISTENT RESULTS.
TO FINE-TUNE YOUR NEWTON+'S ACCURACY WITH ISAAC SOFTWARE, SEE
INSTRUCTIONS IN THE NEXT SECTION
6
Copyright Velocomp LLP 2005-2013