iBike Newton+ Operating Instructions Manual page 11

THE NEWTON+ PROFILE
The Basic Information you entered with the Isaac software, in combination wireless sensor
Pairing and Cal Ride, together form a "Profile", a description of all the things that make
your Newton+ work properly with you and your particular bike.
Your Newton+ can store up to four Profiles in its memory, and your Isaac software
can store as many profiles as you like. Any four of the profiles stored on your Isaac
software can be uploaded into your Newton+.
IMPORTANT: TO LEARN HOW TO STORE A PROFILE ON YOUR COMPUTER AND TO LOAD A
PROFILE INTO YOUR NEWTON+, REFER TO THE "ISAAC SOFTWARE INSTRUCTIONS".
By default, your Newton+ is set to Profile 1. So, all of the information you gathered as part
of your original Newton+ setup is stored in profile 1.
You can create up to four different profiles and store them in your Newton+'s memory. This
is useful if you own two bikes or have two different riding positions (for example, hoods
and TT).
Here is how to select a different profile:
Enter Setup and click the up arrow repeatedly to find the Set Prof (Set Profile) screen. The
number in the top window shows the profile currently selected for your Newton+. In the
screen below all Setup data you have entered and any calibrations you have performed are
stored in "Profile 1".
To select a different profile click the center button. Then, click the up arrow to change the
profile number you wish to select (1-4). To accept your choice, click the center button.
10
Copyright Velocomp LLP 2005-2013