iBike Newton+ Operating Instructions Manual page 5

2. Attach the mount to your bicycle
You'll need to attach your Newton+ mount to your stem, handlebars, or steer tube
(depending on which kind of mount you purchased). Follow the printed instructions
included separately.
Make sure to locate your mount so that your Newton+, when attached, has an
unobstructed view of the wind.
Make sure to remove the double-sticky tape from the mount top and bottom. This tape
helps keep the mount solidly attached to the handlebars and stem.
3. Attach the Speed/Cadence sensor to your bike
Attach your iBike speed/cadence sensor, and speed and cadence magnets, to your bike,
using the printed instructions included separately.
TIP: MAKE SURE THE MAGNETS PASS BY THEIR RESPECTIVE SENSORS WITH A
SEPARATION OF ABOUT 1-2 COIN WIDTHS. THIS SMALL GAP ASSURES THAT THE
SENSORS WILL DETECT THE PRESENCE OF THE MAGNETS.
TIP: IBIKE SENSORS SHIPPED WITH YOUR NEWTON+ HAVE BEEN PRE-PAIRED AT THE
FACTORY AND ARE READY TO USE. THERE'S NO NEED TO DO A "SCAN"
ANT+ SENSOR PAIRING
NOTE: YOUR NEWTON+ HAS ALREADY BEEN
PAIRED WITH ITS SPEED/CADENCE SENSOR.
Your Newton+ will work with any wireless ANT+ sensor. If you're using any ANT+ sensor
other than the speed/cadence sensor shipped with your Newton+, you will need to do
sensor pairing.
Install your speed/cadence sensor on your bike, following the instructions included
separately. If you use an HR strap, fasten it to your body.
To pair your Newton+ to your ANT+ sensors, press-hold the TOP AND BOTTOM arrows
simultaneously, until a "Scan" message appears. After a few moments the pairing process
will be completed and your Newton+ will remember permanently the wireless IDs of your
sensors. ANT+ speed, cadence, speed/cadence, HR, and DFPM sensors can be read.
4
Copyright Velocomp LLP 2005-2013