Installation Of The Door; Lighting Installation - SAMES KREMLIN Inobooth User Manual

Table of Contents

4.2.8. Installation of the door

WARNING : Before installing the door, it is imperative to check that the width of the booth ope-

ning respects the dimension of 950 mm from bottom to top and check the perpendicularity of

the side panels in respect to the bottom box with an angle of a minimum length of 1 m.

Step 1 : Place the door (3) on the booth (2).

Step 2: Loosely position the 3 hinges (1) with 4

screws M6 x 16 per hinge.

Step 3: Before tightening, make sure there is a

clearance of 3 mm all around the door.

Step 4: Lock the brace spacings.

Step 5: Tighten the side panels permanently to

the bottom box.

Step 1: Place the seal (2) on the box (1).

Step 2: Connect the power cable to the lighting

unit (3) and feed the cable through the hole at

the bottom of the box (1) and through the stuf-

fing box (4). Attach the stuffing box (4) to the box

(1).

Step 3: Recess the lighting unit (3) into the hou-

sing (1) and fix it with its seal (2) to the side panel

with 10 M6 x 16 screws.

Step 4: Connect the power cable to the power

supply of the installation.

Step 5: Repeat the procedure for the other lights.

Index revision : A

7143

Table of Contents