Table of Contents
Advertisement
ETC Installation Guide
conditions, portions of the lens can be masked to block the sensor view
of these undesired areas. Reference
Parts and Supplies
The following parts and supplies are included with the Occupancy/Vacancy
Sensor ordered:
• Soft ceiling tile adaptor
• EchoConnect & ESD ground
wire pigtails
Note:
Note:
Installation
The Occupancy/Vacancy Sensor is provided with a twist-lock mounting plate
that can be mounted to a junction box, finished ceiling, or soft ceiling tile.
Determine the installation method and follow the detailed instructions:
• See
• See
• See
Echo Occupancy/Vacancy Sensor
- Follow all local code requirements for terminating wire.
- Use appropriately sized wire nuts (not provided) to secure each
termination.
The EchoConnect pigtail is only required when the sensor is installed
in series with other stations or sensors. If you are not continuing the
data run, direct termination on the control board is recommended.
"Junction Box Installation"
"Soft Ceiling Tile Installation"
"Lens Masking"
on page 10.
Page 3 of 12
Occupancy/Vacancy Sensor
Lens Masking
• 2 each screws, 6-32 x 3/4" and
1 3/4"
• 3 lens masks
on page 4.
on page 5.
page
10.
on
Electronic Theatre Controls, Inc.
Advertisement
Table of Contents
