Procedures For The First-Time Use - Unipulse TM201 Operation Manual

ALM lamp (red)
USB communication and power supply status from the AC adapter are indicated.
Normal:
When the PC application is not communicating:
When the AC adapter is not connected:
Overload:
* The overload indicates a condition where input of approx. ±6V or more is detected.
Power input connector
The dedicated AC adapter included for the TM201 is connected.
Input power is AC100 to 240V (-15%, +10%), free power supply. Frequency is 50/60Hz.
* Refer to P.4 "Connection of power input connector" for connection.
UTMⅡ connection connector
UTMⅡ is connected with the dedicated cable.
* Refer to P.4 "Connection of UTMⅡ" for connection.
USB connector
This part is connected to the PC with the USB cable included.
* Refer to P.5 "Connection of the USB cable" for connection.
1-6.

Procedures for the first-time use

Set up the product following the procedures below.
1.
2.
Hereinafter, use the dedicated PC application to operate the TM201.
3.
Once set, the torque and rotation speed can be checked in the waveform tab of the PC application.
Hereafter, set up the actual load calibration, filter and so on as required.
3
Connect the AC adapter and UTMⅡ. Refer to P.4 "2-1.Connection procedure".
Install the USB driver and the dedicated PC application.
Refer to P.6 "3-2.PC preparation".
After installing this USB driver, connect the TM201 and PC with the USB cable.
Set the sensor type. Refer to P.20 "3-6.Calibration tab" and perform calibration.
Lights off
Lights on
Slow flashes
Fast flashes
1 Outline
Chapter
1
3