Table of Contents
Advertisement
Installation Instruction
ATX Power Supply Connector & Power Switch (POWER)
Be sure to connect the power supply plug to this connector in its proper orientation. The
power switch (POWER) should be connected to a momentary switch. When powering up
your system, first turn on the mec hanical switch of the power supply (if one is provided),
then push once the power button. When powering off the system, you needn't turn off the
*
mechanical switch, just Push once
the power button.
ATX Power Supply Connector
20
1
Note: * If you change "soft-off by PWR-BTTN" from default " Instant-off" to " Delay
4 Secs" in the " POWER MANAGEMENT SETUP" section of the BIOS, the pow er
button should be pressed for m ore than 4 seconds before the system pow ers
dow n.
Hard Disk LED Connector (HD_LED)
The connector connects to the case's IDE indicator LED indicating the activity status of
IDE hard disk.
Reset Switch (RESET)
The connector connects to the case's reset switch. Press the switch once, the system
resets.
Speaker Connector (SPEAKER)
The connector can be connected to the speaker on the case.
Power LED Connector (PWR_LED)
The power LED has three status. When no AC power supply is present, the LED is off.
When the system is in soft power-down status, the LED glows dimly. When the system
is powered up, the LED is on.
Key-Lock Connector (KEY_L)
The connector can be connected to the keyboard lock switch on the case for locking the
keyboard.
M a nua l f or B r i l l i a nX 8V
Advertisement
Table of Contents
