Table of Contents
Advertisement
Installation Instruction
Line-in jack, Microphone-in jack and Line/Speaker-out jack
MIDI/Joystick Connector
The Line-in jack can be connected to devices such as a cassette or Minidisc player for
playback or recording.
The Microphone-in jack can be connected to a microphone for voice input.
The Line/Speaker-out jack is controlled by the jumper JP10 & JP11 (refer to Jumper Set-
tings below for details). If set as Line out, this allows you to bypass the built-in power
amplifier to connect powered speakers or an external amplifier for audio output. If set as
Speaker out, this allows you to connect speakers or headphones for audio output from the
internal amplifier.
The MIDI/Joystick connector allows you to connect a game joystick or a MIDI device.
MIDI/Joystick
Line out/Speaker out
Microphone in
Line in
ATX Power Supply Connector & Power Switch (POWER)
ATX/SFX power supply can both be used on this system. Be sure to connect the power
supply plug to this connector in its proper orientation. The power switch (POWER) should
be connected to a momentary switch. When powering up your system, first turn on the
mechanical switch of the power supply if one is provided, then push once the button of
the momentary switch. When powering off the system, you needn' t turn off the mechani-
*
cal switch, just Push once
the button of the momentary switch.
ATX Power Supply Connector
5V 5V -5V GN D GN D GN D PSON GND -12V 3.3V
20
1
12V 5VSB PS-OK GND 5V GN D 5V GN D 3.3V 3.3V
POWER
Note: * If you change "soft-off by PWR-BTTN" from default "Instant-off" to "Delay
4 Secs" in the "POWER MANAGEMENT SETUP" section of the BIOS, the power
button should be pressed for more than 4 seconds before the system powers
dow n.
Manual for ZillioX 5
20
Advertisement
Table of Contents
