QDI BrillianX 8V Manual page 8

Installation Instruction
Fan Connector (CPUFAN, CHSFAN)
These two fans are controllable. They will be automatic ally turned off after the sys tem
enters suspend mode. Y ou also can choose not to turn the CPUFAN off by setting "CPUFAN
In Suspend" as on in the "POWER MANAGEMENT SETUP" section of the BIOS.
CPUFAN
CHSFAN
Wake-Up On LAN (WOL)
Through the Wake-Up On LAN function, a wake event occurring fr om the network can
wake up the system. If this function is to be used, pleas e be s ure an ATX 2.01 power
supply of which 5VSB line is capable of delivering 720mA, and a LAN adapter which
supports this function are used. Then connect this header to the relevant connector on the
LAN adapter, set "Wake Up On LAN" as Enabled in the "POWER MANAGEMENT SETUP"
section of the BIOS. Save & exit, then boot the operating sys tem once to make sure this
function takes effect.
Wake-Up On Internal Modem (WOM)
Through the Wake-Up On Internal Modem func tion, the system which is in the power-off
status can be powered on by a ring signal received from the internal modem. If thi s function
is to be used, be sure an internal modem car d which supports the function is used. Then
connect this header to the relevant connector on the modem card, set "Modem Ring Re-
sume" to Enabled in the "POWER MANAGEMENT SETUP" section of the BIOS. Save & exit,
then boot the operating system once to make sure this function takes effect.
M a nua l f or B r i l l i a nX 8V