Cisco Catalyst 9200 Configuration Manual page 86

Manually Booting the Switch
Before you begin
Use a standalone switch for this task.
SUMMARY STEPS
1. configure terminal
2. boot manual
3. end
4. show boot
5. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Device# configure terminal
Step 2 boot manual
Example:
Device(config)# boot manual
Step 3
end
Example:
Device(config)# end
Step 4 show boot
Example:
Device# show boot
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
72
Performing Device Setup Configuration
Purpose
Enters global configuration mode.
Enables the switch to manually boot up during the next boot
cycle.
Returns to privileged EXEC mode.
Verifies your entries.
The boot manual global command changes the setting of
the MANUAL_BOOT environment variable.
The next time you reboot the system, the switch is in boot
loader mode, shown by the switch: prompt. To boot up the
system, use the boot filesystem:/file-url boot loader
command.
• filesystem:—Uses flash: for the system board flash
device.
Switch: boot flash:
• For file-url—Specifies the path (directory) and the
name of the bootable image.
Filenames and directory names are case-sensitive.