Cisco Catalyst 9200 Configuration Manual page 105

Configuring Smart Licensing
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12. exit
13. service call-home
14. exit
15. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3
call-home
Example:
Device(config)# call-home
Step 4 no http secure server-identity-check
Example:
Device(config-call-home)# no http secure
server-identity-check
Step 5
contact-email-address email-address
Example:
Device(config-call-home)# contact-email-addr
username@example.com
Step 6 profile CiscoTAC-1
Example:
Device(config-call-home)# profile CiscoTAC-1
Step 7
destination transport-method http
Example:
configure terminal
call-home
no http secure server-identity-check
contact-email-address email-address
profile CiscoTAC-1
destination transport-method http
destination address http url
active
no destination transport-method email
exit
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
Configuring the Call Home Service for Direct Cloud Access
Purpose
Enables privileged EXEC mode.
Enter your password, if prompted.
Enters global configuration mode.
Enters Call Home configuration mode.
Disables server identity check when HTTP connection is
established.
Assigns customer's email address. You can enter up to 200
characters in email address format with no spaces.
By default, the CiscoTAC-1 profile is inactive. To use this
profile with the Call Home service, you must enable the
profile.
Enables the Call Home service via HTTP.
91