Configuring Sdm Templates; Information About Sdm Templates; Sdm Templates And Switch Stacks - Cisco Catalyst 9200 Configuration Manual

Configuring SDM Templates

•
•
•
•
•
•
•

Information About SDM Templates

You can use SDM templates to configure system resources to optimize support for specific features, depending
on how your device is used in the network. You can select a template to provide maximum system usage for
some functions.
Cisco Catalyst 9200 Series Switches support the following templates:
• Advanced
• VLAN
It is recommended that you reload the system as soon as you make a change to the SDM template. After you
change the template and the system reboots, you can use the show sdm prefer privileged EXEC command
to verify the new template configuration. If you enter the show sdm prefer command before you enter the
reload privileged EXEC command, the show sdm prefer command shows the template currently in use
and the template that will become active after a reload.

SDM Templates and Switch Stacks

In a switch stack, all stack members must use the same SDM template that is stored on the active switch.
When a new switch is added to a stack, the SDM configuration that is stored on the active switch overrides
the template configured on an individual switch.
You can use the show switch privileged EXEC command to see if any stack members are in SDM mismatch
mode.
Information About SDM Templates, on page 113
SDM Templates and Switch Stacks, on page 113
How to Configure SDM Templates, on page 114
Monitoring and Maintaining SDM Templates, on page 115
Configuration Examples for SDM Templates, on page 115
Additional References for SDM Templates, on page 117
Feature History for SDM Templates, on page 117
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
5
C H A P T E R
113