Making Wi-Fi Settings By Pin Code Setup (Wps) - Epson WorkForce ES-500W II User Manual

Network Settings
>
1. Hold down the [WPS] button on the access point until the security light flashes.
If you do not know where the [WPS] button is, or there are no buttons on the access point, see the
documentation provided with your access point for details.
2. Press the
button on the scanner's control panel until the
The connection setting starts. The
The light is lit blue when connection is complete.
Note:
Connection fails when the light turns on. After releasing the error by pressing the
move it closer to the scanner, and then try again.

Making Wi-Fi Settings by PIN Code Setup (WPS)

You can automatically connect to an access point by using a PIN code. You can use this method to set up if an
access point is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the access point.
1. Press the
button and the
in blue (approximately 3 seconds).
2. Use your computer to enter the PIN code (an eight-digit number) on the label stuck to the scanner into the
access point within two minutes.
The connection setting starts. The
The is lit blue when connection is complete.
Note:
❏ See the manual provided with your access point for details on entering a PIN code.
❏ Connection fails when the light turns on. After releasing the error by pressing the
point, move it closer to the scanner, and then try again.
Making Wi-Fi Settings from the Control Panel
light and
button on the scanner's control panel simultaneously until
light and
>
Making Wi-Fi Settings by PIN Code Setup (WPS)
light flashes blue (approximately 3 seconds).
light flash alternately.
light flash alternately.
66
button, restart the access point,
light flashes
button, restart the access