Making Wi-Fi Settings By Pin Code Setup (Wps) - Epson DS-80W User Manual

User's Guide
If your router does not have a WPS button, see your router documentation for instructions on enabling WPS
in your router's software.
4. Hold down the button on the scanner until the Ready light flashes, and
alternately (approximately 3 seconds).
When the Ready light,
Note:
Connection has failed when the Ready light stays on,
the router, move them closer together, and then try again.
Related Information
"Basic Scanning" on page 37
&
"Advanced Scanning" on page 53
&
"Network Problems" on page 81
&

Making Wi-Fi Settings by PIN Code Setup (WPS)

You can automatically connect to a wireless router by using a PIN code. You can use this method to setup if the
router supports WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the router.
1. Make sure that the scanner is turned off.
2. Set the switch on the scanner to on.
3. Slide the switch while holding down the
the ready light flashes to turn on the scanner.
Important:
c
You must complete Wi-Fi connection setup within two minutes.
4. Use your computer to enter the PIN code (an eight-digit number) on the label stuck to the scanner.
Connection setup starts. The Ready light flashes, and the
When the Ready light,
Network Settings
and lights stay on, connection is complete.
button and hold them there for approximately 10 seconds until
and lights stay on, connection is complete.
22
and lights flash simultaneously. Restart the scanner and
and lights on the scanner flash alternately.
and lights flash